Updated November 2026

The Sony WH-CH720N noise cancelling headphones are a lightweight, wireless option aimed at people who want active noise reduction without a premium-tier price tag. This guide explains what the model is designed to do, how to set it up and get the most from its noise cancelling, and how to troubleshoot the problems owners most often mention. By the end, you should know whether this pair fits your commute, office or travel routine.

What the Sony WH-CH720N Is Built to Do

Sony positions the WH-CH720N as an on-ear, Bluetooth model with active noise cancelling and a battery life that Sony specifies in the range of around 50 hours with noise cancelling switched on. Its main strength is reducing steady, low-frequency sounds such as airplane engines, HVAC hum and train rumble. Sharp, sudden noises like voices or door slams are reduced far less. Keep that in mind before you buy, because the headphones work best on constant background noise.

Shopping for one? See our guide: Better Noise Cancelling Headphones: 6 Best Picks Compared (2026).

Setting Up Your Headphones for the Best Noise Reduction

Out of the box, the headphones will perform better if you complete a few setup steps. Start with a full charge, then pair them through your phone’s Bluetooth menu. Use the Sony Sound Connect app, which is available for iOS and Android, to confirm the firmware is current and to check the noise cancelling mode settings.

  1. Charge the headphones fully using the USB-C port before first use.
  2. Hold the power button until you hear the pairing tone, then select the headphones from your device’s Bluetooth list.
  3. Install the Sony Sound Connect app and check for firmware updates.
  4. Turn on noise cancelling with the dedicated button or from the app, then adjust the ambient sound settings to suit your environment.
  5. Test the fit by wearing them for a few minutes while playing steady background noise, such as a fan or recorded traffic.

Getting a Good Fit for Better Passive and Active Isolation

Because the WH-CH720N uses on-ear cushions, fit matters a great deal. The ear pads need to seal around the outer ear without creating pressure points. If you wear glasses with thick arms, you may notice a small loss of seal, which can reduce the effect of the noise cancelling. Adjust the headband so the cushions sit flat, and rotate the earcups to match the angle of your head. Owners often report that a secure fit improves low-frequency reduction noticeably.

Quick Fit Checks

  • Listen to a steady noise and toggle noise cancelling on and off to hear the difference.
  • Move your head side to side; the seal should hold without the headphones slipping.
  • If the pads feel tight after an hour, loosen the headband slightly rather than forcing a seal.

Troubleshooting Common Problems

Most issues owners raise fall into three categories: connection drops, weak noise cancelling and battery concerns. The table below lists the usual cause and a practical fix for each.

Problem Likely Cause Fix
Audio cuts out Source device too far or obstructed Keep the phone within line of sight and remove it from your pocket if it sits against your body
Weak noise cancelling Poor seal or noise cancelling turned off Confirm the mode is on and re-seat the ear pads
Battery drains faster Noise cancelling used at high volume for long periods Lower the volume and charge before long trips
Pairing fails Old pairing record on the device Forget the headphones in Bluetooth settings and pair again

If problems continue after these steps, check Sony’s official support pages or consult an authorized service provider.

Common Mistakes to Avoid

  • Expecting full silence from voices or sudden sounds, since the model targets steady noise.
  • Skipping firmware updates, which can affect connection stability.
  • Leaving noise cancelling on when you do not need it, which shortens battery use.
  • Pressing the ear pads too hard, which causes discomfort and can break the seal.

A few accessories can make daily use smoother. A hard-shell case protects the earcups during travel, a USB-C cable gives you a spare for charging at work or on the road, and a short aux cable is useful if you want to listen in a setting where Bluetooth is restricted.
View on Amazon
View on Amazon
View on Amazon

FAQ

Are the Sony WH-CH720N noise cancelling headphones good for flights?

They can help with the constant drone of aircraft engines, which is the type of sound noise cancelling handles best. Bring a charged pair and check the battery level before boarding.

Can I use them without turning noise cancelling on?

Yes, they function as standard Bluetooth headphones with noise cancelling switched off. Sound quality and battery life behave differently in that mode, so test both settings.

How do I know if the seal is right?

A good seal lets you hear low background noise drop noticeably when you switch noise cancelling on. If the effect is weak, adjust the headband and re-seat the pads.

Conclusion

The Sony WH-CH720N noise cancelling headphones suit people who need steady background noise reduced during commutes, flights or office work. Setting up the app, checking the fit and using the troubleshooting steps above will get you the most from them. For a broader comparison, see Sony Wired Noise Cancelling Headphones: How to Choose the Right Pair and Sony Versus Bose Noise Cancelling Headphones: Which Fits You Best (2026).

Owen Palmer

About Owen Palmer

Owen Palmer is part of our editorial team and reviews and edits our brand headphones & noise cancelling guides, checking product details against manufacturer specifications and owner feedback.